Ceramic tiles. Grouts and adhesives - Test methods for grouts Ingestion-build-46800 and develop a test specification

and develop a test specification accordingly

The sorbent tube approach is intended for use under relatively low particulate conditions (typically less than 100 mg/m3) when monitoring downstream of all pollution control devices

NOTE 1 It is the responsibility of the purchaser or specifier to make the appropriate selection from these aspects

Figure 2 — Target domain of the data quality model

Ceramic tiles. Grouts and adhesives - Test methods for grouts Ingestion-build-46800 and develop a test specification1 Scope This part of ISO 13007 describes methods for determining characteristics for grouts used in the installation of ceramic tiles. The following test methods are described: determination of flexural and compressive strength (4. 1); determination of water absorption (4. 2); determination of shrinkage (4. 3); determination of resistance to abrasion (4. 4); determination of transverse deformation (4. 5); determination of chemical resistance (4. 6).